AVE DR8X Guide d'installation télécharger pdf (Page 5)

Dome Control

Dome Connection & Settings:

• See section Connecting Your DVR

for RS-485 port pin definition.

• Refer to the following figure. Connect the R+, R- terminals on the dome camera to the D+, D-

terminals on the RS-485 port by RS-485 cable respectively.

• To set up dome protocol and ID, press MENU to access the Main menu, and select <Camera

Setup>. The available protocols include <DynaColor>, <Pelco D>, <Pelco P>, <AD422> and

<None> (default). Note that ID number must match the ID address defined by the dome.

• To configure the RS-485 parameters, select <System Setup> from Main menu, and then select

<RS485 Setup>. The default

Full-Featured MPEG-4 series DVR RS-485 settings are 9600 Baud,

8 Data Bits, 1 Stop Bit and No Parity.

Dome Control Button:

Set / Go Preset

Toggle Hint

Screen

Iris Open

Focus Near

Zoom In

ESC

Auto / Enter

Iris Close

Focus Far

Zoom Out

Pan / Tilt

1 2 3 4 5 6 7 8 9

Pas de commentaire

AVE DR8X Guide d'installation Page 5