AVE Video Serial Synchronous ATM Interface VSSI-PRO Manuel d'utilisateur Page 19
- Page / 138
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
ADPRO FastTx by Xtralis Installation and User Manual
Doc 11949_06 7
To complete ADPRO FastTx installation, you may need:
• Null modem cable
• Camera and coax cable
• External alarm switches or other devices
• ISDN Terminal Adaptor or Modem
• PC or Laptop running Microsoft
®
Windows
®
2000 Professional or Windows
®
XP
Professional, with an Ethernet Port or a serial port and a DVD drive.
2.5 Mounting the ADPRO FastTx
2.5.1 Rack Mounting
The ADPRO FastTx models are housed in a 3 U high chassis for mounting in a 19" rack with a
layout as shown in the following figure. To ensure long term electronic equipment reliability, it is
advisable to:
• mount the unit clear of other equipment that can dissipate large amounts of heat,
• ensure adequate air flow (either convective or forced) between the unit and its
surroundings, and
• ensure that the fan opening on the rear panel is not blocked by other equipment.
Figure 3: ADPRO FastTx Front Panel for 19 inch Rack Mount Models
2.6 Setting the Video Standard
ADPRO FastTx can be set to operate using either PAL (CCIR) or NTSC (RS170) video
standards. Once a standard has been selected, all video inputs and the monitor output
(composite video) will be configured to use the same standard.
To set the required video standard, use the Configuration DIP switch on the rear panel.
Configuration Switch # 10 ON = NTSC
OFF = PAL
Note: To be configured correctly, this switch must be set before power on.
- ADPRO FastTx by 1
- Installation and 1
- User Manual 1
- Compliance of Power Cord 5
- Connection to Other Equipment 5
- Contact Us 5
- Declaration of Conformity 6
- Contents 7
- List of Figures 9
- Doc. 11949_06 10
- List of Tables 12
- 1 Introduction 13
- Monitoring 14
- 2.1 Physical Location 15
- Instructions 16
- 2.3.2 Static Discharge 17
- 2.3.3 Grounding Requirements 17
- 2.5 Mounting the ADPRO FastTx 19
- 2.7 Setting up the PC 20
- Doc 11949_06 9 21
- Doc 11949_06 11 23
- Doc 11949_06 13 25
- Null-modem Cable Wiring 27
- Doc 11949_06 17 29
- Doc 11949_06 19 31
- Doc 11949_06 21 33
- 2.10 Adding a New Site 35
- 2.12.2 Front Panel LED 37
- 2.14 Firewall Configuration 38
- 3 ADPRO FastTx Connectors 39
- 3.1 Power Connection 40
- Doc 11949_06 29 41
- 3.2.2 COMMS 2 42
- 3.3 Audio 43
- 3.3.1 Audio Switch Port 44
- 3.3.3 Audio Configuration 45
- 1 2 3 45678 9 46
- 3.3.4 Zoned Audio 47
- 3.4 Video Input Connections 48
- 3.5 Video Output 49
- 3.6 Configuration Switches 50
- 3.7 Alarm Inputs 51
- Doc 11949_06 41 53
- 3.8 Control Outputs 54
- 3.9 PTZ Connection 55
- 44 Doc 11949_06 56
- 3.9.1 PTZ Port Setup 57
- 3.11 Data Connection 59
- 3.12.4 Push to Talk - Pin 7 60
- 3.12.6 Fault Relay 61
- 4 Programming ADPRO FastTx 63
- Doc 11949_06 53 65
- 4.3.3 Site Details 67
- 4.3.4 Date/Time Settings 68
- 4.3.5 Licensing 69
- 4.3.6 Communications 70
- Ethernet Properties 71
- Subnet Mask 72
- Default Gateway 72
- Video Data Rate 73
- Modem/TA Model 74
- Line Type 74
- Data Rate 75
- Dial Time 75
- Answer Rings 75
- Initialisation String 75
- Redcare Setting 75
- Doc 11949_06 65 77
- Base Port Number 78
- Connection Timeout 78
- Enable WAN Optimisation 78
- 4.3.7 Call List 79
- Main Communications Link 80
- 4.3.8 Connected Equipment 81
- General Alarm Relay Settings 82
- PTZ Settings 82
- 4.3.9 Cameras 83
- Camera Settings 84
- Doc 11949_06 75 87
- Activity Detection Tab 88
- Contrast Monitoring Tab 89
- 4.3.10 Monitor 90
- 4.3.11 Transaction Devices 90
- 4.3.12 Transparent Data Port 91
- Baud Rate 92
- Data Bits 92
- Stop Bits 92
- Flow Control 92
- 4.3.13 Alarm Inputs 93
- Alarm Input Type 94
- Hold Time 94
- 4.3.14 Presidium Inputs 95
- Presidium Input Settings 96
- 4.3.15 Control Outputs 97
- 4.3.16 Audio 98
- Audio General Properties 99
- 4.3.17 Arming / Disarming 100
- Indicate Active Sensor 101
- 4.3.18 Operational Behaviour 102
- 4.3.19 Operational Modes 102
- Mode Selection 103
- Mode Name 103
- Doc 11949_06 104
- 4.3.20 Camera Behaviour 105
- Alarm Logic 106
- Event Inputs 106
- Doc 11949_06 95 107
- Event Response 108
- Dial Out on Event 109
- Dial Out on Video Loss 109
- Dial Out on Invalid Contrast 109
- Guard Tour Settings 110
- Doc 11949_06 99 111
- Doc 11949_06 101 113
- 4.3.22 Entry/Exit Behaviour 114
- Doc 11949_06 103 115
- Exit Path and Delay 116
- 4.3.23 Maintenance 117
- Zone Isolate 118
- SitePulse 119
- 5 Event Log 121
- Doc 11949_06 111 123
- 112 Doc 11949_06 124
- Doc 11949_06 113 125
- 114 Doc 11949_06 126
- Doc. 11949_03 115 127
- 116 Doc. 11949_03 128
- Doc 11949_06 117 129
- 7.1 Software Upgrade Process 131
- 8 Specifications 133
- 122 Doc 11949_06 134
- Doc 11949_06 123 135
- 124 Doc 11949_06 136
- Te le me t ry 136
- Doc 11949_06 125 137
- 126 Doc. 11949_05 138
Produits connexes et manuels pour Mise en réseau AVE Video Serial Synchronous ATM Interface VSSI-PRO
(48 pages)© 2020, manymanuals.fr. Tous droits réservés | 0.021 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels